Tire Shine Spray Directions:

For the best results, surfaces must be thoroughly cleaned and completely dry to allow product to properly bond.

1. Shake bottle before use.
2. Spray applicator a few times and massage onto surface to create a thin, even layer.
3. Leave product to air dry for a beautiful glossy shine! For a less gloss, rich black luster, after 10 minutes, wipe off excess with a microfiber towel.
4. For EXTREME GLOSS: Lightly spray product directly onto tires. Wipe off over-spray and leave to air dry.
5. To prevent sling, before driving vehicle, always check for and wipe away excess product from rims, side-wall grooves and tire tread grooves.

Notes:

• Applies milky in color and turns clear when dry.
• Gloves are recommended for easy clean-up after use.
• Use on tire side-walls, wheel wells, and any type of rubber, plastic or vinyl trim.

WARNING: Not meant for motorcycles or bicycle tires. May cause slippery surface, never apply to tire tread.

Important Application Tips:

#1 - Surfaces must be thoroughly cleaned of all old dressings, oils and dirt. This may take two or three good hard rounds of scrubbing with a stiff bristle brush. This is especially important if you have been using a lot of the really harmful and really damaging petroleum/solvent based tire dressings.

#2 - To prevent sling, ensure surface is thoroughly dry to allow our product to properly bond.